Previously we kept direct link dependencies in OriginalLinkLibraries.
The property exposes the information in the CMake language through the
get/set_property commands. We preserve the OriginalLinkLibraries value
internally to support old APIs like that for CMP0003's OLD behavior, but
the property is now authoritative. This follows up from commit d5cf644a
(Split link information processing into two steps, 2012-11-01).
This will be used later to populate the link interface properties when
exporting targets, and will later allow use of generator expressions
when linking to libraries with target_link_libraries.
Also make targets depend on the (config-specific) union of dependencies.
CMake now allows linking to dependencies or not depending on the config.
However, generated build systems are not all capable of processing
config-specific dependencies, so the targets depend on the union of
dependencies for all configs.
If you think about adding a new testcase then here is a small checklist you
can run through to find a proper place for it. Go through the list from the
beginning and stop once you find something that matches your tests needs,
i.e. if you will test a module and only need the configure mode use the
instructions from section 2, not 3.
1. Your testcase can run in CMake script mode, i.e. "cmake -P something"
Put your test in Tests/CMakeTests/ directory as a .cmake.in file. It will be
put into the test binary directory by configure_file(... @ONLY) and run from
there. Use the AddCMakeTest() macro in Tests/CMakeTests/CMakeLists.txt to add
your test to the test runs.
2. Your test needs CMake to run in configure mode, but will not build anything
This includes tests that will build something using try_compile() and friends,
but nothing that expects add_executable(), add_library(), or add_test() to run.
If the test configures the project only once and it must succeed then put it
into the Tests/CMakeOnly/ directory. Create a subdirectory named like your
test and write the CMakeLists.txt you need into that subdirectory. Use the
add_CMakeOnly_test() macro from Tests/CMakeOnly/CMakeLists.txt to add your
test to the test runs.
If the test configures the project with multiple variations and verifies
success or failure each time then put it into the Tests/RunCMake/ directory.
Read the instructions in Tests/RunCMake/CMakeLists.txt to add a test.
3. If you are testing something from the Modules directory
Put your test in the Tests/Modules/ directory. Create a subdirectory there
named after your test. Use the ADD_TEST_MACRO macro from Tests/CMakeLists.txt
to add your test to the test run. If you have put your stuff in
Tests/Modules/Foo then you call it using ADD_TEST_MACRO(Module.Foo Foo).
4. You are doing other stuff.
Find a good place ;) In doubt mail to cmake-developers@cmake.org and ask for
advise.
7653862798